Custom 29-Inch Elevator Touchscreen for a South Korean Project

2026-11-05

A customer in South Korea needed a wall-mounted touchscreen for destination floor selection in an elevator lobby. They supplied photos and dimensioned drawings of the original unit. RusinDisplay matched the exterior to those references, designed the internal electronics and interfaces, and built a prototype for the customer to review.

From Customer Drawings to a 3D Model

The exterior had to match the reference unit’s dimensions, corner geometry, frame profile, mounting holes, light strip positions, and black finish. The two excerpts below show part of the customer’s design.

Customer drawing showing the elevator touchscreen enclosure’s corner geometry, dimensions and fastening details.

Customer drawing excerpt showing the corner geometry and fastening details.

Customer drawing showing the side frame profile, dimensions and mounting hole positions.
Customer drawing excerpt showing the side frame profile and mounting hole positions.

RusinDisplay modeled the enclosure in 3D and made custom extrusion tooling for the frame. We applied the specified black anodized finish to the aluminum alloy frame and rear panel.

RusinDisplay 3D rendering of the custom wall-mounted elevator touchscreen enclosure.

RusinDisplay’s 3D rendering of the custom enclosure.

Designing the Electronics and Interfaces

With the exterior dimensions set by the customer, RusinDisplay designed the internal component layout and interface arrangement to fit the enclosure. The hardware integrates the LCD, touch sensor, speakers, and two side light strips. The finished unit is configured as a monitor and provides two CAN ports, two LAN ports, and one HDMI port.

ItemProject configuration
Display29-inch wall-mounted stretched LCD
Resolution and brightness1920 × 540 pixels, 500 nits
Touch and front glassProjected capacitive (PCAP) touch, tempered glass
HousingAluminum alloy with a black anodized frame and rear panel
Lighting and audioLED light strips on both sides, built-in speakers
System configurationMonitor only
Interfaces2 × CAN, 2 × LAN, 1 × HDMI

Factory Demo and On-Site Installation

RusinDisplay built one prototype first. The factory video shows touch operation and the side light strips illuminated.

Touchscreen and side lighting demonstration at the factory.

The prototype was then installed in an elevator lobby in South Korea. The photo shows the wall-mounted unit displaying building information and a destination floor selection keypad.

installation-south-korea.webp	Custom touchscreen installed in a South Korean elevator lobby, displaying building information and floor selection controls.
The custom touchscreen installed in a South Korean elevator lobby.

The customer approved the prototype. RusinDisplay plans to ship 500 units in the first batch and 1,000 units in the second batch.